Channel Scanner (Option 312)
How to Set Up Channel Scanner
How to Set Up Channel Scanner
This section briefly reviews the steps in setting up a channel scan
measurement. If you are not familiar with this process or would like more
information, refer to
1. Define some channels (refer to
2. Select
3. Modify scale and specify color bar coding—Modify the scale and assign
4. Enable Data Logging Settings: Press Measure 1 or Trace 6 > Data Logging
Keysight N9915-90020 User's Guide
"How to Define a Channel and Use Channel
Scanner").
a. Select a
Scan
Mode—choose:
—
Range
Specify total channels, channel spacing or
—
Custom List
b. Then modify channels based on the selected scan mode
Display
Type—choose:
— Bar ChartV or
— Bar ChartH or
— Channel Pow or
— Strip Chart or
— Then
More
and
—
Chart Overlay
—
Scan&Listen
colors to low and high power channels (bars):
Press
Scale/Amptd
Then one of the following:
—
Red Limit
to set the power level and color scale for high power
channels.
—
Blue Limit
to set the power level and color scale for low power
channels.
— Others: Scale,
Ref
to view the Data Logging softkeys and set the
Save/Recall, and
More
— Record (Outdoor Logging) or
— Play (If you have previously stored data recordings.) or
— View
a. To set the
Record Settings
"How to Define a Channel and Use Channel
Specify a list of channels from an editor
or
Level,
RF
Atten, etcetera as desired.
>
Indoor Map Data Logging
(Outdoor Mapping only)—choose:
Scanner".
Record
Settings,
Record
or
Signal
Locate.
647