Advertisement
Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Record-Play files are saved to:
—
—
Learn more about file settings, refer to
Enabling and Setting Up Indoor Map Logging
1. Press Measure 1 >
2. Press
IMPORTANT!
When you recall a *.kdat file, you are able to add mapping points, but you
will only be able to save the changes as a *.png. file. Optionally, if you save
a file as a *.png file and then recall the file, you can add data points and
save the changes as a *.kdat file.
506
——
If File Folder is set to Default then Record-Play files are save-recalled
to:
"[CurrentDevice]\RecordPlayback\[Current mode]\"
If File Folders are set to System, then Record-Play files are
save-recalled to:
"CurrentDevice\<UserSelectedFolder>\
Data Logging
Indoor Map Data Logging
—
Record Indoor Data
to plot data points and lines of bearing to emitter signals.
—
Recall Indoor Log File
You can recall a log file and add/delete directional finding lines of
bearing and map data to previously saved files. Re-save them and
resume data collection at a later time.
After a *.png is opened for a new recording or a *.kdat file is recalled
for editing and displayed on the FieldFox, then choose from the
following:
Sets the type of icon that is used to display a
Icons
map's data points.
Flag Point
Line
Save Image (PNG)
Saves the current displayed
map to a *.png file (default filename is
"MapImageFile"). This softkey is available (active)
when View Maps = ON.
Chapter 33, "File Management."
>
More
— then choose:
– Use this option to load a new floor–plan image
– (if you have previously stored data (*.kdat)).
Keysight N9915-90020 User's Guide
Advertisement
Chapters
