Advertisement
ERTA (Extended Range Transmission Analysis) Mode - Option 209
Start Connection Wizard
Start Connection Wizard
Use the FieldFox Connection Wizard to guide you through the following
physical setup.
On the Receiver unit:
— Press Mode then
— Then Meas Setup 4 then
STEP 1: Select [Start] when ready
— Press
— At any step, press
STEP 2: Connect Trigger and LAN cables
— LAN: Connect a LAN cable to each unit. The units can either both be
— Trigger signals: On each unit, connect the Ref/Trig Out SMB (m) connector
— RF connections
624
ERTA
Start
Exit
connected to the internet on the same network through a switch or router,
or they can be connected directly to each other (a crossover cable may be
necessary).
on the FieldFox side panel to the Ref/Trig In SMA (f) connector on the other
FieldFox top panel.
Preferred method (pictured above):
Connection Wizard
to end the wizard.
Keysight N9915-90020 User's Guide
then Start.
Advertisement
Chapters
