Keysight Technologies C Series User Manual page 516

Fieldfox analyzers

Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option

233), and GPS Receiver (Option 307))

How to Use Data Logging (Option 352)

length of the line of bearing to extend it far enough to allow other

points to cross, indicating a possible emitter location.

Accept Point

and returns to the previous menu.

– Opens up menu of bearing point editing softkeys.

Choose from:

Select Point

directly enter a new angle or line length or use the

the rotary knob to edit these values.

Direction Line OFF ON

(default = OFF).

Adjust Angle

Rotate the line about the current point (your current location) to point

towards the highest signal strength seen by your directional antenna.

You can rotate the knob to rotate the line, or you can type an angle

into the active entry directly.

Adjust Angle

length of the line of bearing to extend it far enough to allow other

points to cross, indicating a possible emitter location.

Delete Point

– deletes the currently selected point.

Clear Points

– Deletes all of the displayed bearing points and lines.

– Enters a value for the line's length. Adjusts the

– verifies the new point is to be added

– Enter the point you want to edit. Then you can

– Enables/disables the direction line

– Enters the angle of the current point's line.

– Enters a value for the line's length. Adjusts the

Keysight N9915-90020 User's Guide

Chapters