Advertisement
Indoor and Outdoor Mapping – Option 352 (Requires Spectrum Analyzer Mode (Option
233), and GPS Receiver (Option 307))
How to Set Up Mapping Settings
Setting up Data Logging
There are two types of data logging:
"Enabling Outdoor Map Logging" on page 503
"Enabling and Setting Up Indoor Map Logging" on page 506
See also,
"Option 352 Outdoor Maps Setup Procedure" on page
Opening the Data Logging settings:
Enabling Outdoor Map Logging
If you have already setup your outdoor or indoor map logging:
— Then
— Then
— Then
Keysight N9915-90020 User's Guide
"Option 352 Indoor Maps Setup Procedure" on page 491
Press Mode (Channel Scanner (Option 312) only) >
—
on the number of options installed, may not be necessary) >
Scanner
— Press Measure 1 (Channel Scanner (Option 312) only) or Trace 6 >
Data Logging
Record
to being logging data or
Play
If this softkey is active, you are currently recording or you have
recalled a previously stored data logging file
When Play is pressed, then choose:
Cursor Position
—
the current data log being played (i.e., Cursor Position is active only
when playback is paused).
This softkey is only available in Channel Scanner and Phased Array
Antenna modes (i.e., The Cursor Position softkey is not available for
OTA mode).
—
Maps
– to open a softkey menu enable map view and related features
(e.g., Data Selection, Red/Blue Limits, Zoom, and Labels & Icons).
Learn more, refer to step 3.
or
View
(available in Channel Scanner mode and with Outdoor Mapping
only)
Then choose:
Exit
—
to leave the current View softkey menu and return to the previous
menu.
—
Zoom
use this softkey zoom in/out.
and
use this softkey to move the data log play cursor in
and
495.
More
(Depending
Channel
503
Advertisement
Chapters
