Advertisement
SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)FUTURE
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
EMF Setup Procedure
When the USB antenna correction factors are imported, EMF (Option 358)
couples many settings to ease setting up the EMF measurement (e.g.,
Apply Corrections is enabled, all X, Y, and Z antenna axes are enabled, and
Amp Corr Select is set to TriAxial XYZ).
1. Setup the FieldFox Spectrum Analyzer for a Channel Power measurement.
If necessary, this step can be skipped and done after the USB antenna is
set up.
2. Connect a USB antenna's RF cable to the SA RF Input, port 2 and the USB
Only Agos Advanced Technologies SDIA–6000 Triaxial Isotropic USB
antenna is currently compatible with EMF (Option 358).
3. Importing and selecting the X/Y/Z antenna factors:
If the antenna factor import is successful, the FieldFox displays:
"Success: Antenna Factors Imported: Tri-Ax Antenna ID:
->[R] Antenna ID: SDIA-6000-1006 ->[]". The last 4-digits will vary
for each antenna (i.e., "1006" value will vary).
If the FieldFox displays this error Error: USB antenna Error: Not
found or Unable to communicate with antenna. Ensure it is
connected. is displayed, verify the USB antenna is connected correctly.
See also,
Keysight N9915-90020 User's Guide
a. Press Mode >
SA
b. Press Measure 1 >
See also,
"Channel Measurements" on page
connector to a FieldFox USB port. See also,
to
Chapter 15, "USB Antennas – (Full Capability Requires EMF Option 358,
and either SA mode (Option 233 Mixed Analyzers) or OTA—5G NR / 5G NR
EVM Conducted Option 378)."
a. Press System >
— Then
Import Antenna
antenna's memory over the USB connection (this may take 5
seconds or so and vary with the Triaxial antenna).
This softkey is only active when Antenna Select is set to Tri Axial.
"Troubleshooting" on page
— Then
Antenna Select [Tri Axial]
Manual).
>
Channel Measurements
Figure 9-23 on page 232
Utilities
EMF Antennas
>
– to import the antenna factors from the
472.
verify Triaxial is selected (Default =
Channel Power
>
220.
and
233
Advertisement
Chapters
