Advertisement
Reflection Mode (SA Models) - Option 320
Reflection Mode Settings
How to perform Normalization
To Port 1, connect a known device (usually an Open or Short) to which
reflection measurements are to be normalized.
— Press Trace 6
— Then
The yellow data trace displays the current measurement with trace math
applied. The math operation symbol [D/M] is displayed on the lower left corner
of the screen. Learn more about Trace Math in
page 760
Data interpolation is NOT supported. If the Resolution setting is changed
with Trace Math enabled, the FieldFox will disable the math operation.
Keysight N9915-90020 User's Guide
Normalize
.
"All about Trace Math" on
559
Advertisement
Chapters
