Advertisement
Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5G TF
Option 377, 5G NR / 5G NR EVM Conducted Option 378
How to Use Data Logging (OTA Options 370, 372, 377, and 378)
When GPS is enabled,
display. Learn more in
If Data Logging or Playback is not occurring when you think it should,
check the following:
— Is the sweep in HOLD? (upper-left annotation), or check the Sweep
— Is Recording or Playback Paused? (mid-left annotation)
— Is the Data Logging or Playback Interval set too long? (Configuration
How to Record a Data Log Procedure
Data Log-Play files are saved to:
—
—
— Press Trace 6 >
— Then for Outdoor Logging, press
During recording, choose from the following:
—
—
—
—
408
GPS R
"GNSS (GPS+) and GPS" on page
menu for Continuous set to OFF.
settings.)
If File Folder is set to Default then Data Log-Play files are save-recalled
to:
"[CurrentDevice]\RecordPlayback\OTA"
If File Folders are set to System, then Data Log-Play files are
save-recalled to:
"CurrentDevice\<UserSelectedFolder>\
More
>
is displayed in the left of screen graticules.
Pause Resume
Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue recording. See
"How to Play a Data Log" on page
also
Stop
Immediately stops recording and opens a menu to name/rename and
save your data log. For more, refer to
page
820.
Record Settings
(Outdoor Mapping only) opens a softkey menu to enable
you change your record related settings. For more, refer to
Logging Configuration settings:" on page
Recall Save/Recall
opens a softkey menu to enable you to save and recall
your data log and related file settings. For more, refer to
Logging Configuration settings:" on page
Learn more, refer to
Chapter 16
page 503
is indicated at the bottom of the FieldFox
Data Logging
>
Record
410.
"How to use the FieldFox labeler " on
409.
409.
Mapping and
"Setting up Data Logging" on
Keysight N9915-90020 User's Guide
795.
"To change Data
"To change Data
Advertisement
Chapters
