Keysight Technologies C Series User Manual page 439

5G Rapid Prototype Phased Array Antenna – Option 360
How to Set Up Phased Array Antenna Settings
Spectrum information is not recorded. Only the TableChart data are saved.
See
Data Log-Play files are saved to:
Learn more about file settings, refer to
9. Press
10. If recording, then:
Keysight N9915-90020 User's Guide
b. Record Save/Recall
recordings.)
—
—
—
—
— Then
"How to Record a Data Log" on page
— If File Folder is set to Default then Data Log-Play files are save-recalled
to: "[CurrentDevice]\RecordPlayback\PAA"
— If File Folders are set to System, then Data Log-Play files are
save-recalled to: "CurrentDevice\<UserSelectedFolder>\
c. Indoor Map Data Logging
Recall Indoor Log
— Then choose
Back to return to previous menu.
— Pause Resume Temporarily halts recording until pressed again. The
incoming trace continues to sweep. Press again to continue
recording.
— Stop Immediately
— The Save the log file menu opens. Edit the filename and
press Done to exit menu. See Settings below and
change Data Logging Configuration settings:" on
page 456.
— To change your file settings or measurement interval.
Learn more, refer to
Configuration settings:" on page
— (Press Record
to begin a new recording.)
(If you have previously stored data
Save Log File or
Recall Log File
or
User Folder Def System
File Type
(Default = KML) CVS or DREC (DREC is
only available with Option 360 only)
Auto Save OFF ON
456.
Chapter 33, "File
- then
File.
Navigate OFF
Zoom, Pan, Record Data,
"To change Data Logging
(Default = Default) or
(Default = OFF).
Management.".
Record Indoor Data or
ON, Data Selection,
More
"To
456.
439