Advertisement
USB Antennas – (Full Capability Requires EMF Option 358, and either SA mode (Option
233 Mixed Analyzers) or OTA—5G NR / 5G NR EVM Conducted Option 378)
How to Set Up a USB Antenna (Also, Known as EMF Antenna)
How to Set Up a USB Antenna (Also, Known as EMF Antenna)
IMPORTANT! See also,
"SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)FUTURE."
This section reviews some general high level steps in setting up a USB antenna
measurement. If you are not familiar with this process or would like more
information on specific EMF measurement setups, refer to:
— SA Mode:
— OTA Mode:
USB Antenna Setup Procedure
1. Select the mode and set up your measurement. Refer to
If necessary, this step can be skipped and done after the USB antenna is
set up.
2. Connect a USB antenna. Refer to
Only Agos Advanced Technologies SDIA–6000 Triaxial Lsotropic USB
antenna is compatible with EMF (Option 358). See also
(Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)FUTURE"
Chapter 13, "Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE
TDD Option 371, 5G TF Option 377, 5G NR / 5G NR EVM Conducted Option
378".
3. Importing and selecting the X/Y/Z antenna factors:
Keysight N9915-90015 User's Guide
"Alignments" on page
"How to Set Up EMF Settings (Requires EMF (Option 358), GPS
(Option 307), and SA Mode (Option 233–Mixed Analyzers))" on page 230
"How to Set Up EMF Mode Settings (Requires EMF (Option
358) and 5G NR (Option 378))" on page 400
"Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option
371, 5G TF Option 377, 5G NR / 5G NR EVM Conducted Option 378"
Chapter 9, "SA (Spectrum Analyzer) Mode (Option 233–Mixed
Analyzers)FUTURE".
a. OTA – 5G NR and SA Mode:
Press System >
Utilities
206, in NA
Figure
15-1.
EMF Antennas
>
>
mode,Chapter 9,
Chapter 13,
or to
Chapter 9, "SA
and
467
Advertisement
Chapters
