SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)FUTURE
How to Set Up EMF Settings (Requires EMF (Option 358), GPS (Option 307), and SA
Mode (Option 233–Mixed Analyzers))
Keysight N9915-90020 User's Guide
—
Default
(Default – when no Tri Axial antenna is detected).
—
Src/Rcvr Split
source side antenna measurements.
—
Triaxial XYZ
when a compatible triaxial antenna's factors have
been imported) for measuring channel
measurements and EMF.
— Then <Back to exit to the previous softkey menu.
e. Optional (Tri-Axial XYZ Antenna):
Verifying antenna and cable corrections are applied:
i. Press Scale/Amptd >
— Then verify the
softkey is set to Auto (This is the default setting when a
compatible USB antenna's correction factors have been
imported, via the System softkeys).
— Then verify the
Z axis Antenna
or disabled individually, but for EMF measurements all
three axes should be enabled (i.e., Antenna = Off, the
applications are setting the X/Y/Z).
— Then Press
softkeys menu.
Verify
where an additional cable has not been connected to
the triaxial antenna. Before a cable can be used with
the EMF measurements it needs to have corrections
loaded. If you are going to use a cable, then choose as
needed:
Receiver side only antenna measurements
to work with non-triaxial receiver and
(default, when Channel Power is on and
More
Corrections
>
Apply Corrections Auto Disabled
X axis
Antenna,
are all OFF. These can each be enabled
Cable Off
to open the cable correction
Cable
is ON. This can be disabled for applications
—
Cable Off
to enable a cable for use in your
antenna measurement.
—
Edit Cable
displays a cable corrections table
that you can edit
—
New
displays a cable corrections table that
you can edit with new cable correction
content.
Yes
– Choose
Yes
data
No
– Choose
No
view
Y axis
Antenna, and
to overwrite the current cable
to exit the cable data edit table
235