Advertisement
Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5G TF
Option 377, 5G NR / 5G NR EVM Conducted Option 378
How to Set Up Over–the–Air (OTA) Mode Settings
374
— Then
Lmax
indexing in ascending order in time 0 to (L
are 4, 8, or 64 (Default = Auto).
— Then
More
SS Meas
(NSA /
DSS), EMF, Advanced. See also,
Cell or Cell(s) and Use OTA" on page
——Then
— 5G NR EVM Conducted NR:
— Then
Cell ID Auto
(default = Auto).
— Then
Bandwidth
FR1 100 MHz).
— Then
Resource Grid
component carrier and optionally export scan results to 5G
NR.
——Then
—— Then
—— Then
——Then
— Then
SSB
that are coupled to the Resource Grid SCS setting.
——Then
——Then
Sets the current half frame SS/PBCH blocks
opens a menu for
Capture
DMRS,
SSB Offset
Detection,
Advanced
opens a menu for
Length,
Drive
Speed,
DMRS. See also,
"How to Define a Cell or Cell(s)
and Use OTA" on page
Sets the Cell ID to Auto or to Manual
Sets the FR1 / FR2 bandwidth (Default =
Opens a softkey menu to select the
SCS Auto
- the SCS value is coupled to the
center frequency and FR1 and FR2. Manual
choices are 15 kHz and 30 kHz. Default = Auto.
Grid Start
only settable when SSB Auto is
set to OFF. Default = 0.
Grid Size
only settable when SSB Auto is
set to OFF. Default = 273.
Export to 5G NR Setup
scanned table of information to 5G NR.
Opens a softkey menu to select the SSB settings
SSB Auto-Detect OFF ON
Enables/disables SSB Auto-Detect state. When
SSB auto-detection is enabled, the SSB offset,
SSB Case, Lmax, Periodicity and, optionally, SCS
are all auto-detected in the measurement. When
disabled, the settings can be set manually.
Default = ON.
SSB Offset
- Opens a menu to set the SCS
values.
Keysight N9915-90020 User's Guide
– 1). Choices
max
Length,
Drive
Speed,
LTE Coexistence
"How to Define a
384.
Capture
Phase
Comp,
SS Meas
384.
– Export the current
-
Advertisement
Chapters
