Advertisement
3. Use the
arrows to select ON.
4. Use
Offset
to shift the limit line UP or DOWN. Learn how below.
Figure 30-9
Build From Trace (2 of 2)
Limit Options
How to set Limit Options
1. Press
Exit
if the limit table is visible.
2. Then Options.
3. Then choose from the following:
—
Beep
—
On Pass
Keysight N9915-90020 User's Guide
Data Analysis FeaturesDELETE_IF
All about Limit Lines
The following are Limit Options for Limit Lines in CAT, NA, NF, RTSA, and
SA. But, RTSA mode has some exceptions:
–When using the Spectrogram measurement, Limit lines are only available
when the display Measurement Type for Spectrogram View used is:
Overlay.
–RTSA mode does not support any PASS or FAIL features.
–Beep, Warning, and Margin softkeys are grayed out (not active) in RTSA
mode.
Audible beep sounds when a sweep passes.
753
Advertisement
Chapters
