Advertisement
5G Rapid Prototype Phased Array Antenna – Option 360
How to Use Data Logging/Playback (Option 360)
How to Use Data Logging/Playback (Option 360)
Data log-Play files are saved to:
—
—
Data Logging and Playback enables you to log phased array antenna trace
data and play them back at a later time. Use this feature to monitor table data
activity over a period of time.
Data logs can be saved to the FieldFox Internal memory, an SD Card, or a USB
flash drive.
This section assumes you have already completed the initial setup and have a
phased array antenna scan displayed on the FieldFox.
Screen Annotation
During a data logging or playback session, the following is displayed in the
top-center area of the screen:
—
where:
—
—
— The name of a recording can be changed using Manage Sessions. Learn
See also, the FieldFox User's Guide's "System Settings" chapter.
When GPS is enabled,
display. Learn more, see the FieldFox User's Guide's "System Settings"
chapter.
The Phased Array Antenna mode can display and be data logging/played back
in field strength units, when the units are changed:
— Press Scale /Amptd >
Keysight N9915-90020 User's Guide
If File Folder is set to Default then Data Log-Play files are save-recalled
to:
"[CurrentDevice]\RecordPlayback\PAA"
If File Folders are set to System, then Data Log-Play files are
save-recalled to:
"CurrentDevice\<UserSelectedFolder>\
Rec: 55/55 2018-12-31 03:26:11 PM
55/55
is the current and total trace number: currently trace is 55 of 55 total
scans.
2018-12-3103:26:11 PM
more in
"To change Data Logging Configuration settings:" on page
GPS R
— dBmV, dBuV, W, V, A, dBmA, or
See
Figure 14-18 on page
is the date and time of recording.
is indicated at the bottom of the FieldFox
More
>
Unit
then choose:
dbuA
455.
(Default Units: dBm)
456.
455
Advertisement
Chapters
