Advertisement
IQ Analyzer (IQA) – Option 351
Alignments
Alignments
The IQA mode requires all three alignment types: amplitude, RF burst, and
channel equalization. Refer to the SA chapter's
information on all alignments.
Trace Display States (IQA Mode)
If you have Option 351 I/Q Analyzer option, you can directly save your data
as MATLAB files (*.mat). Refer to
351", on page 293
If you have the FieldFox's Remote Server mode (89600 VSA software
connectivity), you can use the VSA software to capture and record your
data as MATLAB files (*.mat). Learn more about FieldFox and 89600 VSA
software, refer to
Hardware/SA Option 233)"
http://rfmw.em.keysight.com/wireless/helpfiles/89600B/WebHelp/89600
.htm.
— In IQA Mode you can display up to four of the following types of trace
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display the Trace States
— Press Trace 6.
— Then
— Then
— Then choose from the following Trace States:
Keysight N9915-90020 User's Guide
and to
Chapter 18, "Remote Server Mode (Requires SA
states.
All IQA settings are applied to all displayed traces. See also
Trace (IQA and SA Mode)" on page
Trace 1,2,3,4
repeatedly to select a trace number to display or change
its state. Traces are displayed in the following colors:
— Trace 1 – Yellow
— Trace 3 – Orange
State [current setting]
—Clr /Wr
(Clear/Write) Displays the actual measured data for each
acquisition.
—MaxHold
Displays the maximum response of the input signal at each
data point over multiple acquisitions. See also Average Count in
"Adjusting the Measurement Setup Settings" on page
"Alignments" on page 206
Chapter 11, " IQ Analyzer (IQA) – Option
Chapter 33, "File Management", on page
and to
738.
Trace 2 – Blue
Trace 4 – Green
for
817.
"Marker
308.
319
Advertisement
Chapters
