Keysight Technologies C Series User Manual page 580

Fieldfox analyzers

Power Meter (USB/LAN) Mode - Option 302

Troubleshooting

This section contains the following:

If a LAN sensor cable or LAN sensor is not communicating properly with the

If the FieldFox LAN is removed during the use of the LAN sensor, the

following steps can be taken to re-establish control of the Sensor:

1. Reconnect the LAN sensor to the FieldFox and await confirmation the

2. Once FieldFox has obtained its IP address again, press the Reconnect

If the Sensor LAN is removed during the use of the LAN sensor, the

following steps can be taken to re-establish control over the

measurement:

1. Reconnect the LAN cable to the sensor.

2. Observe the LEDs near the LAN cable connection:

"If the FieldFox LAN is removed during the use of the LAN sensor, the

following steps can be taken to re-establish control of the Sensor:" on

"If the Sensor LAN is removed during the use of the LAN sensor, the

following steps can be taken to re-establish control over the

measurement:" on page 578

FieldFox has obtained its IP address via the connection.

A self-assigned IP address may be shown briefly while FieldFox tries to get

connected to the LAN again after it has been removed. Before proceeding

to the next step, ensure the correct IP has been obtained by the FieldFox.

a. You can view the IP address by selecting:

System Configuration

to exit the LAN menu.

Press Meas Setup 4 >

in the softkey menu.

The FieldFox will attempt to restore the connection and the settings for the

a. The PWR LED will turn on while the Sensor is waking up and

initializing.

LAN Sensor Settings

Keysight N9915-90020 User's Guide

to display the current

Chapters