Table of Contents
Advertisement
This section describes how to prepare an existing module for an expansion module addition and how to add
expansion modules. The section also describes how to install a multi-module system.
Required Tools
The following is a list of tools that you should have available before beginning the installation:
•
24 mm open end wrench
•
16 mm open end wrench
•
13 mm open end wrench
•
8 mm nut driver or open end wrench
•
6 mm hex wrench
•
3 mm hex wrench
•
2.5 mm hex wrench
•
X-axis rail alignment tool (3-00147-01)
•
Digital level
Pre-Installation
1
If this is an existing installation, unlock the 24 mm leg lock nuts and raise the leveling legs of the control
module or control module/expansion module unit until the complete system is resting back on its
casters.
Important: Do not separate any existing control module/expansion module assemblies.
2
Position the control module or control module/expansion module in its intended location.
3
Determine the quantity and position of expansion module's to be added.
4
Make sure the floor area is the appropriate size to allow for installation. Verify that the module is
positioned correctly to accommodate the multi-module installation; there should be 32 inches of service
space available in the front and back.
5
Ensure that the leveling legs of all frames will not be resting on tiles that will need to be raised after the
system has been installed.
Scalar i2000 Installation Guide
Installing a Multi-Module System
17
Advertisement
Table of Contents
