Choosing An Installation Location - ADIC FastStor 2 User Manual

2. Inspect the shipping box for damage. If you notice any damage, report it to the shipping
company immediately.
3. Open the shipping box and remove the accessories package. Set the accessories package
aside for now.
4. Lift the autoloader and padding out of the box and place it on the work surface, top facing up.
CAUTION:
5. Carefully remove the shipping padding from the left and right sides of the autoloader. Then
remove the bag from the autoloader.
Save the packing materials in case you need to move or ship the
NOTE:
autoloader in the future.

Choosing an Installation Location

Choose an installation location that meets the criteria in
information about autoloader specifications.
Table 4-1 Location Criteria
Requirement
Standalone requirements
Room temperature
Power source
Weight
Air quality
Humidity
22
Do not set the autoloader on its end or side.
Criteria
Select a location that is flat, sturdy, level, and close to a host
system server. Do not place the autoloader on the floor or other
carpeted surfaces.
CAUTION: Do not place the autoloader on its side or
upside down or stack items that weigh more than 5 KG
(11.02 lbs) on top of the autoloader.
10-35º C (50-95º F)
AC power voltage: 100-127 VAC; 200-240 VAC
Line frequency: 50-60 Hz.
NOTE: Locate the AC outlet near the autoloader. The AC
power cord is the product's main AC disconnect device and
must be easily accessible at all times.
26 lbs (12 kg)
Minimal sources of particulate contamination. Avoid areas near
frequently used doors and walkways, stacks of supplies that
collect dust, printers, and smoke-filled rooms.
CAUTION: Excessive dust and debris can damage
tapes and tape drives.
20-80% RH
Table 4-1. See Specifications for more
6-00515-03 Rev A