Configure Sample Series Menu - kruss DS7000 Series User Manual

8.7.2

Configure sample series menu

This is the procedure
This is the procedure
The Configure sample series menu is accessible via the Start sample series menu by
pressing the OK button.
The name of the sample series can be edited in the Configure sample series menu just as
it is in the Start sample series menu.
The table of the measurement sequence contains all sample positions to be measured
on the sample plate. During the sample series, the sample positions are measured in the
order of the rows of the table.
At the start of the Configure sample series menu, the table contains as many rows as was
predefined in the Start sample series menu. The top row contains the first sample position
and the bottom row the last sample position.
Individual or multiple rows can be selected via touch screen (highlighted in green) or
deselected. By pressing the table headings, the entire table is selected or deselected.
Rows can be removed from the table.
1. Select the row you want to remove
2. Press Remove
New rows can be added to the table. The following rules apply:
- Rows are always inserted below the last selected row.
- New rows automatically get a sample position, which is 1 greater than the previous
row.
- If the automatically assigned sample position already exists in another row, an input
field is opened, which awaits the entry of a sample position. This also applies if the
automatically assigned sample position is greater than there are positions on the
sample plate.
- No row can be generated without a valid sample position.
- New rows await the input of a sample ID. An empty sample ID can be confirmed.
- Several rows are added in succession, each awaiting an input of a sample ID.
This only applies if the automatically assigned sample position is not already assigned
in a different row or is greater than there are positions on the sample plate.
- Adding multiple rows can be stopped by pressing the Cancel button.
1. Select the row under which you want to add a new row
2. Press Add
3. Enter the sample position of the new row and confirm with OK (this point is only
necessary if no automatically assignable sample position is possible)
73
Routine operation