kruss DS7000 Series User Manual page 102

Methods menu
Explanatory notes
Measurement mode
The measurement mode is used to determine the number of measurements.
Labelling of measurement modes in the results memory:
0 = One-shot measurement
1 = Interval measurement
2 = Continuous measurement
One-shot For One-shot measurement, one measurement value is
measurement recorded.
Interval measurement For interval measurement, several measurement values are
recorded at set intervals. A mean value is calculated from the
measurement values and displayed. The individual measured
values and the associated raw values (nD) can be produced
in the results list where required.
Interval [s] = 2 to 600, in whole numbers
Measurements = number of measurements 2 -99, in whole
numbers
Continuous For continuous measurement, measurement values are
measurement recorded at set intervals.
The measurement is started when the method is accessed.
A small green spot next to the Measure key indicates
measurement is taking place.
The results are not saved automatically. Individual
measurement results are saved by pressing the Measure key.
The measurement is stopped when another method is
accessed.
The results are labelled under RESULT > Measurement
mode: Continuous measurement.
Alarm profile
Lower and upper limit values can be set for the measurement values of a method. If
the limit values are exceeded or not met, the measurement result is labelled. The alarm
profiles can only be defined for the results of Scale 1.
The labelled measurement results can be filtered in the results menu.
Selection menu:
:
none There is no evaluation of measurement results with the
defined limit values.
Alarm profiles list Pre-defined alarm profiles.
102
Explanatory notes