Table of Contents
Advertisement
Chapter 6 - Installation
6.1
Select site
6.2
Connect hoses to the frequency oscillator
6.2.1
Standard connections and Luer syringe for manual filling
Attention!
Overheating damage
h Do not place the device near heat sources (e.g. heating).
h Do not expose the device to direct sunlight.
h Ensure that air is permitted to circulate freely.
Important note!
Shocks and direct sunlight lead to incorrect measurement results.
The installation site should fulfil the following conditions:
• The site should be free of vibration or shocks.
• The surface should be flat and stable.
• Do not expose the device to direct sunlight.
Depending on the type of filling (manual or semi-automatic) and the connecting pieces
on the frequency oscillator, the hoses that must be connected are different.
If the sample or the rinsing fluid is to be filled into the frequency oscillator manually with a
Luer syringe through the infeed piece, proceed as follows:
1. Stick the drain hose into the drainage piece (2)
2. For filling, stick the Luer syringe into the infeed piece (1).
1
Standard infeed piece for the Luer syringe
2
Standard drainage piece for the draining hose
37
Installation
Advertisement
Table of Contents
