kruss DS7000 Series User Manual page 53

3. Press SySTEM > Tab Functions > Peristaltic pump START to transport the liquid into
the frequency oscillator.
4. Stop the pump by pressing SySTEM > Tab Functions > Peristaltic pump STOP if no
more liquid should be sucked in.
Drain 1. Remove the filling hose from the rinsing vessel.
2. Press SySTEM > Tab Functions > Peristaltic pump START to remove liquid from the
frequency oscillator.
3. Press SySTEM > Tab Functions > Peristaltic pump STOP if no more liquid is dripping
from the waste hose.
For the next step (drying the frequency oscillator), prepare the device as follows:
Dry
1. Place an empty waste vessel underneath the filling hose.
Abfall
Warning
If the hose juts into the waste liquid during the drying process, there is a strong
spray.
h Use an empty waste vessel where possible.
h Take care to ensure that the end of the hose does not fall into the liquid.
h Wear suitable protective equipment when using corrosive liquids.
air tube
DS7050
drain tube
filling tube
rinsing liquid
air
DS5060
drain tube
filling tube
waste
53
Initial start-up
waste tube
waste