kruss DS7000 Series User Manual page 55

2. Begin the second step.
The cleaning solution is pumped off.
For the next, third step (drying the frequency oscillator), prepare the device as follows:
Dry
1. Hang the filling hose in an empty waste vessel.
Abfall
Warning
If the hose juts into the waste liquid during the drying process, there is a strong
spray.
h Use an empty waste vessel where
h Take care to ensure that the end of the hose does not fall into the liquid.
h Wear suitable protective equipment when using corrosive liquids.
2. Start the next, third step > Drying.
The air pump stops after a set time.
The frequency oscillator should now be clean and dry.
DS7060
filling tube
rinsing liquid
air
DS5060
drain tube
filling tube
waste
possible.
55
Initial start-up
waste tube
waste