Removing The Fb Read Pulse Motor - Riso RZ9 Series Technical Manual

Hide thumbs Also See for RZ9 Series:

CHAPTER 12: FB ORIGINAL SCANNING SECTION

8. Removing the FB Read Pulse Motor

(1) Switch off the machine power, remove the stage glass and scanner cover;rear.

(2) Remove the mounting screws (M3x6: 4pcs) of the FB read pulse motor mounting bracket, unhook the

timing belt located inside the scanner unit and detach the motor with the mounting bracket attached.

(3) Detach the FB read pulse motor from the bracket by removing screws (M3x6: 2pcs).

< Precaution in Assembly >

Pull the bent edge of the motor bracket in the direction indicated by an arrow on the photograph below to apply

adequate tension to the timing belt when tightening the mounting screws of the FB read pulse motor bracket

onto the scanner unit.

FB read pulse motor

DANKA AUSTRALIA PTY. LTD.

Motor bracket

[ 12 - 14 ] - Rev. 0.2

FB read pulse motor