Mechanism; Master On The Drum Check Mechanism (Before Printing) - Riso RZ9 Series Technical Manual

Hide thumbs Also See for RZ9 Series:

CHAPTER 9: PRINT DRUM SECTION

Mechanism

The machine checks for the presence of the master on the print drum at the start of a print job..

With a push of the Start key to begin the printing operation, the print drum starts to rotate and at drum angle 40

degrees from the position-A, the master sensor checks if a master is wrapped on the print drum or not.

If a master is found on the print drum, the printing operation takes place, but if a master is not detected, the

machine stops. Once the master is detected on the print drum, the information is memorized on the machine.

The master sensor no longer checks for the master on the print drum from the next printing job until a new

master is made, print drum is pulled out of the machine, or the power to the machine is turned OFF.

Print drum at 40

degrees from

DANKA AUSTRALIA PTY. LTD.

Reflection preventing cloth

[ 9 - 2 ] - Rev. 0.2

Master sensor