Advertisement
[ Removing the Piston assemblies of the Separation Pump and the Air Dumper ]
The piston of the separation pump can be removed in the state in which the separation pump assembly is
attached on the machine.
In case of the air dumper pistion, it is necessary to remove the air dumper assembly from the machine
beforehand.
Although the following explanation is related with the separation pump, the air damper pistion can be removed
following the same instruction.
(1) Switch off the machine power, remove the rear cover, and swing open the PCB bracket of the power supply
PCB and mechanical control PCB.
(2) Remove the E-ring holding the arm of the piston onto the air pump gear assembly, and slide off the armfrom
the air pump gear assembly.
(3) Rotate the piston assembly 90 degrees, pull the piston out to the tip edge of the air pump cylinder
andswing the arm out towards you to make room for the air pump gear assembly to come out.
(4) Remove the E-ring on the air pump gear assembly and detach the gear assembly from the machine.
(5) Pull the piston assembly out from the air pump cylinder.
0344
DANKA AUSTRALIA PTY. LTD.
Cylinder
Arm
< Piston Assembly >
[ 3 - 15 ] - Rev. 0.2
CHAPTER 3: MAIN DRIVE
Air pump gear
assembly
E-ring
Arm
0345
E-ring
RZ9 Series
Advertisement
Chapters
