Sliding Operations At The Beginning Of The Print Operation - Riso RZ9 Series Technical Manual

7. Sliding operations at the beginning of the print operation

Basic operations
The auto exit tray section is electrically connected to the HC Control PCB in the main unit. The paper stopper
and paper guides move to the appropriate positions according to the paper size at the beginning of a print
operation.
First, all fences are moved to accommodate the widest size. When they reach the HP sensor positions, they
are determined to be at their reference positions.
The paper guides then narrow the width accommodated according to the fence width on the paper feed side.
The paper stopper moves based on the size of paper set in the standard paper feed tray.
If there is paper printed in the pervious print job in the exit tray
When the exit tray paper detection sensor detects paper printed in the previous print job in the exit tray, the
sliding operations are disabled if the print paper is smaller than in the previous job.
If the printed paper is larger than the previous paper, sliding operations are activated to move
the paper guides and stopper to their proper positions according to the paper size.
When using nonstandard-size paper
For nonstandard paper sizes, the paper guides move with reference to the fence width on the paper feed side,
and the paper stopper moves to either the fully open or half-open position, based on the reading returned by the
paper size detection sensor.
When using postcard-size paper
For postcard size paper, the paper stopper moves first to prevent fence interference, then the paper guides start
sliding.
Other
Fine adjustment of fence slide positions can be performed from the menu.
When thin paper, standard, thick paper, or custom paper is selected in the paper information setting, the
fences stop precisely at the set positions. (The settings must be entered in Test mode.)
If the machine fails to operate due to a problem in the auto exit tray mechanism, disconnect the connection
cable to enable machine operations.
DANKA AUSTRALIA PTY. LTD.
[ 8 - 11 ] - Rev. 0.2
CHAPTER 8: PAPER EJECTION SECTION
RZ9 Series