Removing The Paper Ejection Sensor And The Transfer Belts - Riso RZ9 Series Technical Manual

CHAPTER 8: PAPER EJECTION SECTION

6. Removing the Paper Ejection Sensor and the Transfer Belts

(1) Switch off the machine power and remove the following components.
- Paper receiving tray
- Paper ejection cover
- Suction unit
(2) Remove the paper ejection suction plate (M4 x 8; 2pc).
In mounting the paper ejection suction plate back on the suction unit, make adjustment referring to the last
page of this chapter.
0822
(3) Lift the driven shaft assembly by hand and unhook it from the unit.
In mounting it back, make sure that it is hooked correctly in position.
(4) Detach suction center plate by removing screws (M4 x 6; 4pc).
In mounting the suction center plate back on the suction unit, make sure that it does not pinch the transfer
belts.
Suction center plate
DANKA AUSTRALIA PTY. LTD.
Driven shaft assembly
[ 8 - 18 ] - Rev. 0.2
Paper ejection suction plate
Suction upper assembly
0823
RZ9 Series