Advertisement
Jam errors
Error Type
A01 [Master feed error]
A01-xxx
Description
Master Mis-Feed
Pull Out Master Making Unit and Rewind Master Roll, then Reset Master in Place.
To reset
Open the master-making unit and rewind the master material on the master roll, and then
display
reset the master, or turn OFF the power and power back ON.
Error Point
Master-positioning sensor does not go ON even after the write pulse motor is activated
201
during the master-positioning, master-cut, or master-loading operation.
Master-positioning sensor does not go OFF even when the write pulse motor is reversed
202
during the master-positioning or at start of master-making operation.
211
Master-positioning sensor is ON during standby.
214
Master-positioning sensor is ON at the start of master making.
215
Faulty gate-array control for the write pulse motor (motor does not stop within set time).
Error Type
A02 [Master loading error]
A02-xxx
Description
Master Loading Error
Pull Out Print Cylinder and Discard Master.
To reset
Pull out the print cylinder and set it back.
display
Error Point
Master-loading sensor was OFF when the master was checked at a specified drum angle
509
during the master-loading operation.
Error Type
A04 [Master disposal error]
A04-xxx
Description
Master Disposal Error
Pull Out Print Cylinder and Discard Master.
To reset
Pull out the print drum and push it back in.
display
Error Point
303
Check Print Drum - Master disposal error / Master disposal jam.
Error Type
A05 [Master present in the master disposal area]
A05-xxx
Description
Master Jammed in Disposal Unit
Pull Out Master Disposal Box and Remove Jammed Master
To reset
Pull out master disposal box and place it back after removing the jammed master in the
display
master disposal area, or turn OFF the power and power back ON.
Error Point
304
Master disposal jam sensor was ON at the completion of the master disposal.
312
Master disposal jam sensor was ON at the start of the master making.
315
Master disposal jam sensor was ON after the completion of the recovery movement.
Error Type
A06 [Check paper feed tray]
A06-xxx
Description
Safety SW on Standard Feed Tray is Activated
Reset paper on Standard Feed Tray
To reset
Change the condition of the paper-feed-tray upper/lower safety switches to ON condition,
display
or turn OFF the power and power back ON.
Error Point
Either the upper or lower safety switch of the paper-feed-tray is OFF.
403
Note: This detection is not made when the machine is in low-power-mode (24V OFF).
DANKA AUSTRALIA PTY. LTD.
Error Conditions
Error Conditions
Error Conditions
Error Conditions
Error Conditions
[ 16 - 19 ] - Rev. 0.2
CHAPTER 16: PANEL MESSAGE
3
5
9
O O O
O O O
O O O
O O O
O O O
3
5
9
O O O
3
5
9
O O O
3
5
9
O O O
O O O
O O O
3
5
9
O O O
RZ9 Series
Advertisement
Chapters
