Removing The Af Original In Sensorr - Riso RZ9 Series Technical Manual

Hide thumbs Also See for RZ9 Series:

5. Removing the AF Original IN Sensor

(1) Remove the top cover by loosening the screws (M4 x 6: 3 pcs) on the front of the top cover and removing

the screws (M4 x 10: 2 pcs) from the rear.

(2) Remove the screw (M3 x 8: 1 pc), disconnect the connector, and remove the AF original IN sensor.

[Precautions in Reassembly]

Following reassembly, adjust the AF original IN sensor by using Test Mode No. 3044 (Original-IN-Sensor

Sensitivity Adjustment).

DANKA AUSTRALIA PTY. LTD.

AF original IN sensor

[ 13 - 13 ] - Rev. 0.2

CHAPTER 13: Simplex AF Unit

Chapters