Riso RZ9 Series Technical Manual page 433

Error Type F40 [Auto Tray Selection - No Paper on Standard Paper Feed Tray]
F40-xxx
Description
Load Paper on Standard Paper Feed Tray
To reset
Load paper on the standard paper feed tray.
display
Error Point
The paper ran out from the standard paper feed tray, when printing from the standard
060 paper feed tray using the Auto tray selection with Feed-tray-relay activated. (Other trays
also paper empty.)
The paper ran out from the standard paper feed tray, when printing from the standard
907
paper feed tray using the Auto tray selection with Feed-tray-relay OFF.
Error Type F41 [Auto Tray Selection - No Paper in Tray-1]
F41-xxx
Description
Load Paper in Feed Tray 1
To reset
Load paper in MTPF Tray No.1.
display
Error Point
The paper ran out from MTPF Tray No.1, when printing from the Tray No.1 using the Auto
061
tray selection with Feed-tray-relay activated. (Other trays also paper empty.)
The paper ran out from MTPF Tray No.1, when printing from Tray No.1 using the Auto tray
908
selection with Feed-tray-relay OFF.
Error Type F42 [Auto Tray Selection - No Paper in Tray-2]
F42-xxx
Description
Load Paper in Feed Tray 2
To reset
Load paper in MTPF Tray No.2.
display
Error Point
The paper ran out from MTPF Tray No.2, when printing from the Tray No.2 using the Auto
062
tray selection with Feed-tray-relay activated. (Other trays also paper empty.)
The paper ran out from MTPF Tray No.2, when printing from Tray No.2 using the Auto tray
909
selection with Feed-tray-relay OFF.
Error Type F43 [Data printing / Paper size mismatch]
F43-xxx
Description !! Unmatched Size -- Current Page and Printing Paper !!
Check Paper Size
To reset
Check paper size, press Cancel or Continue key.
display
Error Point
902 Original size is larger than the paper size.
Error Type F44 [Auto Reproduction Size - Error Between Original Size and Paper Size]
F44-xxx
Description
!! No Auto Reproduction with This Original and Printing Paper !!
To reset
Press [CANCEL] button.
display
Error Point
901 Original size could not be detected (original size out of the specification).
Error Type F45 [Original Undetected]
F45-xxx
Description Original Undetected
Reset Original
To reset
Reset the original in place.
display
Error Point
Auto-tray or Auto-reproduction size is selected, and master making or
954
print to linked printer is started with original undetected
959 Master making or print to a linked printer is started with original undetected.
981 The original not detected when [NEXT] button was pressed in Multi-Up Wizard display.
DANKA AUSTRALIA PTY. LTD.
Error Conditions
Error Conditions
Error Conditions
Error Conditions
Error Conditions
Error Conditions
[ 16 - 37 ] - Rev. 0.2
CHAPTER 16: PANEL MESSAGE
3 5 9
x x O
x x O
3 5 9
x x O
x x O
3 5 9
x x O
x x O
3 5 9
x O O
3 5 9
x x O
3 5 9
x O O
x O O
x x O
RZ9 Series