Advertisement
Adjustment
1. Separator Mounting Position
Checks and adjustment
(1) Using Test Chart No.15, create a master and make prints. Confirm that neither paper jamming on the drum
nor black thin line (caused by the separator touching and scratching the master on the print drum) appears
on the prints.
(sticking) on the drum.
(2) If paper jams on the drum or a thin black line appears on the prints, remove the print drum from the machine
and remove the print drum front cover. Return the print drum back in the machine and switch off the
machine power. The adjustment is to be done with the machine stopped at position-B..
(3) Loosen the two screws on the separator adjusting plate (one located at the right of the print drum and the
other on the machine frame inside the machine at the paper receiving side).
(4) Move the separator adjusting plate up or down to adjust the position of the separator against the print drum,
looking at the gap between the print drum and the tip of the separator through the hole on the front frame of
the print drum (refer to the photographs on next page). Aim with a flash light from the paper receiving side
of the machine if necessary.
- Continues to next page -
Screw
Graduation scale
DANKA AUSTRALIA PTY. LTD.
Note that 5mm white margin is given on top of the prints to check the paper jamming
Separator adjusting plate
0844
[ 8 - 29 ] - Rev. 0.2
CHAPTER 8: PAPER EJECTION SECTION
Screw
0842
0843
0845
RZ9 Series
Advertisement
Chapters
