Advertisement
CHAPTER 11: MASTER REMOVAL SECTION
12. Removing the Master Removal Roller (Upper)
(1) Switch off the machine power and detach the master removal unit.
(2) Press the master removal roller release lever to release the master removal roller (bottom).
(3) Detach the flanged-gear on the operator's side of the master removal unit by removing a snap ring in front
of the flanged gear.
(4) Remove the AF-spring and AR-spring from the master removal unit.
(5) Unhook the round belts from the pulleys on the master removal roller (upper).
(6) Remove a snap ring from the front (operator's side) of the master removal roller (upper). Slide the shaft of
the roller to the front to free the rear side of the roller off the frame of the master removal unit. Remove the
flat-washer from the shaft. Free the front side of the roller shaft from the frame of the unit and remove the
flat-washer from the shaft on the front side also. Pull the master removal roller (upper) out through the
round belts.
* Do not lose the two flat-washers, and do not forget to put them during the assembly.
Flat-washer
Snap ring
Master removal roller (upper)
DANKA AUSTRALIA PTY. LTD.
AF-spring
1149
Round belt
[ 11 - 20 ] - Rev. 0.2
1151
AR-spring
Round belt
Master removal roller (upper)
Flat-washer
1150
RZ9 Series
Advertisement
Chapters
