Riso RZ9 Series Technical Manual page 256

Hide thumbs Also See for RZ9 Series:

CHAPTER 9: PRINT DRUM SECTION

(6) On the second screw holes from the top at the top end of the drum body, use screws (M3x6: 2pcs from

another part of the drum) to tightly hod the drum body onto the drum flanges.

(7) Remove the screen jigs off the print drum, and place the adhesive tape back on the joint section of the drum

body while pushing down the joint section for a tight hold by the tape.

If the joint section of the drum is lifted during the taping, it may result in master-wrinkling during master

loading or causes mechanical noise during printing.

(8) Remove the two screws used by above step (6).

DANKA AUSTRALIA PTY. LTD.

[ 9 - 14 ] - Rev. 0.2

Chapters