Riso RZ9 Series Technical Manual page 186

Hide thumbs Also See for RZ9 Series:

CHAPTER 6: SECOND PAPER FEED SECTION

<< Working on the rear of the machine - continued >>

(7) Remove the E-ring, and then remove the timing gear and timing gear housing assembly.

(8) Remove the E-ring, and then remove the collar and the timing roller bearing assembly.

Timing gear housing assembly

<< Working on the front of the machine >>

(9) Remove the paper sensor (send).

(10) Remove screw (M3x8: 1pc) from the load spring collar. Then remove load spring and load spring collar.

(11) Remove the washer, and also the bearing from the timing roller adjusting plate.

(12) Make a little timing roller slide to rear side, and then remove the timing roller from the bottom.

DANKA AUSTRALIA PTY. LTD.

Timing roller bearing assembly

Load spring collar

[ 6 - 12 ] - Rev. 0.2

Timing roller

adjusting plate

Chapters