Advertisement
CHAPTER 13: Simplex AF Unit
(5) Disconnect the AF cover set switch connector and AF read pulse motor connector, and detach the ground
wire by removing screw (M3 x 6: 1 pc).
(6) Remove the reusable band, detach the harness from the three harness clamps, and move the harness to
the side.
(7) Detach the ground wire from the harness-bracket assembly by removing screw (M4 x 6: 1 pc).
(8) Detach the harness-bracket assembly by removing screw (M4 x 6: 1 pc).
(9) Remove the sensor actuator disc together with the actuator disc spring.
(10)Detach the motor-bracket assembly by removing screws (M4 x 6: 4 pcs).
(11) Loosen the idler assembly securing screws, and remove the idler spring.
(12)Remove the resin clip, spur gear, E-ring, gear assembly, and timing belt No.1, in that order.
[Precautions in Reassembly]
The gear assembly has a built-in one-way clutch. Be sure to install the gear assembly with the stamped
face toward the front.
Reusable band
AF read pulse motor connector
Ground wire
Harness-bracket assembly
DANKA AUSTRALIA PTY. LTD.
Sensor actuator disc
[ 13 - 16 ] - Rev. 0.2
Ground wire from the
harness-bracket assembly
Motor-bracket assembly
AF cover set sensor connector
1322
Actuator disc spring
RZ9 Series
Advertisement
Chapters
