Riso RZ9 Series Technical Manual page 422

CHAPTER 16: PANEL MESSAGE
Error Type B22 [Job separator: Power off]
B22-xxx
Description !! Job Separator is OFF !!
Turn On Power Switch of it
To reset
Press Reset Key and check and switch ON the power of Job Separator.
display
Error Point
With the [Tape separation] function set ON, no power is supplied to the job separator
721
when start key is pressed.
After cluster-A signal turned ON, BUSY-signal stayed [L] more than 7 seconds (power to
727
job separator was turned OFF while the tape is being ejected.
Error Type B23 [Job separator: No tape]
B23-xxx
Description No Paper Tape in Job Separator
Replace Tape Roll
To reset
Press Reset Key and set paper tape in Job Separator.
display
Error Point
With the [Tape separation] function set ON, no tape detected in the job separator when
722
the start key is pressed.
723 No tape remains in job separator upon completion of the tape-ejection operation.
Error Type B24 [Job separator: Tape jam]
B24-xxx
Description Paper Tape Jam in Job Separator
Remove Paper Tape
To reset
Press Reset Key and remove the jammed tape.
display
Error Point
Tape jam detected when the start key is pressed with the [Tape separation] function set to
724
ON.
The tape-jam detection signal is [H] for more than 1.2 seconds after cluster-A signal turns
725
ON (tape misfeed).
Job separator tape-jam detection signal is [L] when the BUSY signal changes from [L] to
726
[H] (or after 7 sec. at [L]) after the cluster-A signal goes ON (tape misfeed).
Error Type B25 [ Sorter - Tray Full Error]
B25-xxx
Description
Check Sorter Panel Display
To reset
Remove papers from the sorter tray.
display
Error Point
704 Sorter tray full.
Error Type B26 [Sorter - Paper Remaining on the Tray]
B26-xxx
Description
Check Sorter Panel Display
To reset
Remove paper from the sorter tray.
display
Error Point
705 Paper remaining on the sorter tray.
Error Type B27 [Sorter - Stapler Error]
B27-xxx
Description
Check Sorter Panel Display
To reset
Check the stapler and correct the stapler problem.
display
Error Point
706 Stapler error command is received from the sorter.
DANKA AUSTRALIA PTY. LTD.
Error Conditions
Error Conditions
Error Conditions
Error Conditions
Error Conditions
Error Conditions
[ 16 - 26 ] - Rev. 0.2
3 5 9
O O O
O O O
3 5 9
O O O
O O O
3 5 9
O O O
O O O
O O O
3 5 9
x x O
3 5 9
x x O
3 5 9
x x O
RZ9 Series