Removing The Master Removal Housing Assembly - Riso RZ9 Series Technical Manual

Hide thumbs Also See for RZ9 Series:

CHAPTER 11: MASTER REMOVAL SECTION

14. Removing the Master Removal Housing Assembly

(1) Switch off the machine power and detach the master removal unit.

(2) Detach the compression gear cover and spur gear to lower the master compression plate.

(3) Press the master removal roller release lever to release the master removal roller (bottom).

(4) Detach the roller hook spring-R from the rear.

(5) Detach the release lever spring from the front, watching out for injuries as the spring is strong.

(6) Disconnect the connector from the side plate-F, and by remove screws (M3x6: 2pcs each) from the front

and rear, remove the master removal housing assembly by sliding it out towards the paper ejection side.

< Precaution on reassembly >

- Fit the boss on the release lever into the groove on the roller hook-F.

Master removal housing assembly

DANKA AUSTRALIA PTY. LTD.

Roller hook spring-R

[ 11 - 22 ] - Rev. 0.2

Release lever spring

Side plate-F