Advertisement
CHAPTER 16: PANEL MESSAGE
Error Type
A16 [Waiting for the master to be removed from the drum]
A16-xxx
Description
Master Remains on Print Cylinder (Drum)
Pull Out Print Cylinder and Remove Master
To reset
Pull out the print cylinder (drum), remove the master around it and insert it back.
display
Error Point
525
Waiting for the master to be removed from the print cylinder (drum).
Error Type
A17 [Cutter error]
A17-xxx
Description
System Error in Master Making Unit
Take Out Master and then Close Master Making Unit Cover
To reset
Open the Master making unit, remove the master and close the master making unit.
display
Error Point
Cutter HP switch is OFF when master-making starts, when the master material is set in
209
the master making unit, or when the machine goes into idle condition.
Error Type
A34 [Requesting for the master to be reset]
A34-xxx
Description
Master Not Set in Place
Insert Lead Edge of Master into Master Entrance and Close Master Making Unit
To reset
Open the Master making unit, re-insert the master material into the master making unit.
display
Error Point
218
Reqesting for the master material to be reset into the master making unit.
DANKA AUSTRALIA PTY. LTD.
Error Conditions
Error Conditions
Error Conditions
[ 16 - 20 ] - Rev. 0.2
3
5
9
O O O
3
5
9
O O O
3
5
9
O O O
RZ9 Series
Advertisement
Chapters
