Removing The Ink Bottle Lock Assembly & Antenna Pcb - Riso RZ9 Series Technical Manual

CHAPTER 9: PRINT DRUM SECTION
8. Removing the Ink Bottle Lock Assembly & Antenna PCB
(1) Make a confidential master on the print drum and pull out the drum from the machine.
(2) Remove the following components.
- Screen assembly
- Master clamp base assembly
- Drum body
- Ink pump assembly
- Ink bottle guide assembly
Removing the Ink Bottle Lock Assembly
(3) Remove screws (M3x8: 2pcs) and detach the ink bottle lock assembly from the ink bottle guide assembly.
Ink bottle guide assembly
Removing the Antenna PCB
(3) Separate the ink bottle guide (top) from the ink bottle guide (bottom) by unhooking the claws.
(4) Remove the antenna PCB from the PCB holder.
0939
Ink bottle guide (bottom)
DANKA AUSTRALIA PTY. LTD.
Ink bottle lock assembly
Ink bottle guide assembly
Ink bottle guide (top)
[ 9 - 18 ] - Rev. 0.2
Antenna PCB
0940
0938
PCB holder
0941
RZ9 Series