Removing The Transfer Unit - Riso RZ9 Series Technical Manual

CHAPTER 5: MULTI-TRAY PAPER FEED SECTION

6. Removing the Transfer Unit

(1) Disconnect three connectors and detach the FL transfer motor assembly (M4x8 screws; 6 pcs).
During the above procedure, remove the rectangular black spong cover and unhook the timing belt.
(2) Pull out both Tray No.1 and No.2, and remove following parts.
1) Stripper pad angle adjust knob
2) Stripper pressure adjust knob
3) Stripper adjust cover (top)
4) Stripper adjust cover (bottom)
5) Stripper adjust shaft [ total 4 pcs ]
DANKA AUSTRALIA PTY. LTD.
FL transfer motor
0524
Stripper adjust cover
(top)
Stripper pad angle
adjust knob
Stripper pressure
adjust knob
Stripper adjust cover
(bottom)
0526
[ 5 - 16 ] - Rev. 0.2
0525
Unhook the timing belt
(after removing the black
sponge cover)
Stripper adjust shafts
0527
Stripper adjust shafts
RZ9 Series