Removing The Print-Positioning Intermediate Gear - Riso RZ9 Series Technical Manual

Hide thumbs Also See for RZ9 Series:

CHAPTER 6: SECOND PAPER FEED SECTION

5. Removing the Print-positioning Intermediate Gear

(1) Switch off the machine power and remove the rear cover.

(2) Remove the E-ring and detach the print-positioning intermediate gear.

<< Precaution on Reassembly >>

Mount the print-positioning intermediate gear back on the machine after inserting the 8mm diameter Jig shaft

into the position-B phase alignment hole on the paper feed area so all other gears are aligned in position-B.

DANKA AUSTRALIA PTY. LTD.

Print positioning intermediate gear

[ 6 - 14 ] - Rev. 0.2