Removing The Main Belt - Riso RZ9 Series Technical Manual

Hide thumbs Also See for RZ9 Series:

CHAPTER 3: MAIN DRIVE

2. Removing the Main Belt

(1) Remove the Pressure spring.

(2) Insert 8mm diameter shaft JIG into the position-B phase alignment hole on the paper feed timing area (refer

to page 3-6.)

(3) Unplug the position B sensor connector and remove detachable wire band (1 pc) from main cover assembly.

(4) Loosen screws (M4x8 : 2pcs) on the tension lever, and release the tension of the main belt.

(5) Remove the Sponge part.

(6) Detach the main motor bearing assembly (M4x8 : 3pcs).

(7) Dismount the main cover assembly (M4x8 : 5pcs).

- continued on next page -

Detachable wire band

Tension lever

Main motor bearing assembly

DANKA AUSTRALIA PTY. LTD.

Position B sensor

[ 3 - 8 ] - Rev. 0.2

Main shaft assembly

Main cover assembly