Advertisement
2. Individual Test Procedures
1) Checking sensors and switches
Indicates the sensor and switch status with audible beeps.
• Detected:
• Not detected: Buzzer sounds at 0.5 second intervals (long beeps).
2) Checking motors and solenoids
Switch on by pressing the [Start] key, then press the [Start] or [Stop] key to switch off.
* Error checking is not performed during the operation. Note that moving parts may lock if at their limit
positions.
3) Checking unit operations
(1) Switch on by pressing the [Start] key, then initiate unit operation. Error checking is performed in
basically the same way as for normal operation. Some operations will halt when the sequence is
complete, while other operations will continue until you press a key ([Stop] or [Start]).
(2) A continuous audible tone is emitted to indicate an error. To cancel errors, press the "Reset" key.
4) Data clear
Press the [Start] key to clear the data. [In Action] message appears while clearing the data. The
activating ends automatically and [End] message appears when completed.
5) Data check
Press the [Start] key to display data.
* Data check only displays the various settings. These settings cannot be changed here.
6) Data setting
(1) Press the [Start] key to display and change the data currently set.
(2) Change data using the numeric keys. Use the [*] key to change the [±] display.
(3) Once settings have been changed, press the "Start" key to confirm the data and return to standby
mode. Press the "Stop" key to cancel the settings and return to standby mode.
* The settings will be set to their default values if values beyond the specified setting ranges are entered.
The settings are also set to their default values if values are entered in units other than the units
specified.
DANKA AUSTRALIA PTY. LTD.
Buzzer sounds at 0.1 second intervals (short beeps).
[ 17 - 3 ] - Rev. 0.2
CHAPTER 17: TEST MODE
RZ9 Series
Advertisement
Chapters
