Advertisement
2. Adjusting the Paper Ejection Suction Plate
Checks and adjustment
<< When the pressure roller adjusting plate on the front side is adjusted >>
(1) Loosen the mounting screws (bind, M4 x 8, 2 pcs) on the paper ejection suction plate.
(2) In accordance with the adjustment value of the pressure roller adjusting plate, align the front side of the
paper ejection suction plate with the line engraved on the front side of the transport plate toward the paper
feed side. Also confirm that the rear side aligns with the longest engraved line.
(3) Tighten the mounting screws.
*
Make sure that the pressure roller is parallel to the paper ejection suction plate during adjustment.
*
When the roller adjusting plate is moved one increment mark (1 mm) on the scale, also move the paper
ejection suction plate one increment mark (1 mm).
<< When the pressure roller adjusting plate on the rear side is adjusted >>
(1) Loosen the mounting screws (bind, M4 x 8, 2 pcs) on the paper ejection suction plate.
(2) In accordance with the adjustment value of the roller adjusting plate, align the rear side of the paper ejection
suction plate with the line engraved on the rear side of the transport plate toward the paper feed side. Also
confirm that the front side aligns with the longest engraved line.
(3) Tighten the mounting screws.
*
Make sure that the pressure roller is parallel to the paper ejection suction plate during adjustment.
*
When the roller adjusting plate is moved one increment mark (1 mm) on the scale, also move paper ejection
suction plate one increment mark (1 mm).
0822
DANKA AUSTRALIA PTY. LTD.
[ 8 - 31 ] - Rev. 0.2
CHAPTER 8: PAPER EJECTION SECTION
Paper ejection suction plate
Transport plate
0850
RZ9 Series
Advertisement
Chapters
