Advertisement
(5) Pull out the flat cable guiding box in the direction indicated by an arrow mark on the photograph below, just
enough to unhook from the master making unit, and disengage it from the maser making unit.
(6) Push both the flat cable guiding box and flat cable support plate back into the machine.
(7) From the top of the master making unit, remove the four shoulder screws and detach the unit from the
machine by lifting it.
- Precaution in assembly continues on next page -
Master making unit
Flat cable guiding box
< Master making unit >
DANKA AUSTRALIA PTY. LTD.
Hooks on the flat cable
support plate
1569
Shoulder screws
1571
[ 15 - 29 ] - Rev. 0.2
CHAPTER 15: MASTER MAKING SECTION
< Rear >
Shoulder screws
Shoulder screws
Shoulder screws
< Front >
Flat cable guiding box
1570
1572
1573
RZ9 Series
Advertisement
Chapters
