Removing The Ink Bottle Guide Assembly - Riso RZ9 Series Technical Manual

7. Removing the Ink Bottle Guide Assembly

(1) Make a confidential master on the print drum and pull out the drum from the machine.
(2) Remove the following components.
- Screen assembly
- Master clamp base assembly
- Drum body
- Ink pump assembly
(3) Remove the inspection cap from the inside of the ink bottle guide.
(4) Gently pull out the connector pin from the Antenna PCB. Then disconnect the ink bottle set switch
connector and detach the two reusable bands from the print drum frame.
(5) Remove screws(M3x8: 4pcs), and lift out the ink bottle guide assembly from the print drum after sliding it
towards the center of the drum.
0935
Ink bottle guide assembly
0937
DANKA AUSTRALIA PTY. LTD.
Inspection cap
[ 9 - 17 ] - Rev. 0.2
CHAPTER 9: PRINT DRUM SECTION
Antenna PCB
Antenna connector
pin
Reusable bands
0936
0934
Bottle set SW connector
RZ9 Series