Chapter 12
Introduction
This chapter describes how to perform tasks performed either by root or the
system administrator. These tasks fall under the general heading of system
administration and include firmware upgrades, resetting the unit to defaults,
and disaster recovery procedures.
Upgrading the Firmware
Web Interface
You will need to download the latest firmware version to a system on the same
subnet as the Digi CM. The latest firmware can be downloaded from the Digi
support site at: http://cm.digi.com. Do the following to upgrade the firmware:
1. Access the web interface.
2. Under the System administration heading, choose Firmware upgrade.
3. Choose the Browse button and locate the firmware download.
4. Choose Upgrade. The Digi CM will automatically reboot when the upgrade
Resetting Factory Defaults
There are two ways to reset the unit to the factory defaults. The quickest and
simplest method is to push and hold the hardware factory default reset button
until the Ready light on the front panel goes out. The reset button is located on
the back panel of the unit next to the Ethernet port. The arrow points to the
reset button's location.
Chapter 12
is complete.
Sys te m A dm in i st rat io n
Factory reset button
System Administration
81