Table of Contents
Advertisement
3EM13853AF
Issue 01, September 2007
DLP-128
Replace Common Control Card (CCC)
PURPOSE
This procedure provides instructions to replace a Common Control Card (CCC).
PREREQUISITE
Contact Alcatel-Lucent CTAC at 1-888-252-2832 prior to performing this procedure.
GENERAL
For information on TL1 command syntax, refer to the 1677 SONET Link Commands and Messages
manual (PN 3EM13852AF).
RECOMMENDED TOOLS
Phillips screwdriver, #2 × 6-inch
STEP
PROCEDURE
1
DANGER: Possibility of personal injury. Cards can be installed or removed with rack
power on. Hazardous electrical potentials are present; use extreme care when
installing or removing cards with power on.
WARNING: Possibility of equipment damage. This equipment contains static-
2
sensitive devices. Refer to
Is a CCC card present in both slots 9 and 10?
3
Enter
4
Observe output. Note software release on system.
5
6
CAUTION: Possibility of service interruption. Failure to replace CCC while node is
powered up may cause node to copy wrong release of system software. Not following ESD
precautions may severely damage replacement card.
Enter
7
Enter
8
Replace Common Control Card (CCC)
If yes, go to step 4.
If no, go to step 109.
RTRV-PRMTR-NE;
RTRV-EQPT::CCC-9;
RTRV-EQPT::CCC-10;
Introduction
for special handling instructions.
DLP-128
5-27
Advertisement
Table of Contents
