DLP-129
Figure 129-1. Attach Cable-Tie Brackets to Chassis Mounted Connector Panel
Position connector panel so the two guide pins enter two guide holes in chassis.
7
WARNING: Possibility of equipment damage. To prevent damage to connector
8
pins, do not force panel into connector. Make sure connector of panel aligns
correctly with chassis connector before seating it.
Gently press connector panel into connector on 1677 SONET Link until it seats. Do
9
not force it.
WARNING: Possibility of equipment damage. To prevent thumbscrew damage,
10
never tighten a thumbscrew with a power screwdriver or more than .09 m-kg
(8 in.-lbs).
Align four captive screws on panel with threaded holes, and tighten each screw using
11
a #2 Phillips screwdriver.
Reconnect cables to transmit and receive ports on connector panel.
12
Go to step 29.
13
Replace Connector Panel on Equipment Rack
Undo captive screws that secure cable to back of connector panel. See figure 129-2.
14
5-40
ALIGNMENT PIN
3EM13853AF
Issue 01, September 2007
677-0109-1
090804
Replace DS3 Connector Panel